Canon IP5200 Printer User Manual


 
7
2) Preparing your new CISS for installation
Please ensure the following are present with your CISS.
(1) Air filters x5
(2) Silicone nozzle seal x 5
(3) Cable ties (spare)
(4) Double sided tape tabs (spare)
(5) Syringe and filling needle
(6) Spare elbow joints and connections
(7) Single spacer clips (for use on MP500/530 only)
b) Remove your CISS from the box and check the there are no leakages or
cracks and that the silicone tubing is not damaged.
c) Inspect the silicone tubing for air pockets.
d) Close the tube clamp located on the side of the CISS by rolling the roller down.
This will squeeze the silicone tubing which will prevent ink flow.
1
2
4
5
3
If you have an excessive amount
(5cm or more) of air in the tubing,
you will need to prime the unit.
Please refer to page 24 of this
installation manual.
This will prevent any problems with
your print quality further down the
track.
If you do not close this valve,
ink will flow back into the
reservoir from your
cartridges.
6
Engage the tube
clamp by rolling
the roller down