Filter
Top Products
Menu function settings 82
Keystone LED Mode
Adjusting keystone distortions
MENU > Keystone
This function allows you to correct keystone
distortions.
Use this if you cannot correct the distortion
using Auto Keystone.
Press the / buttons to adjust the values.
When you have finished making adjustments,
press the MENU button or the BACK button.
• Keystone can be adjusted within ± 40
degrees.*1
• If you perform manual keystone
adjustment, the auto keystone function is
disabled until the next time the projector is
started. However, you can enable auto
keystone again by setting Auto Keystone
to Off, and then setting it back to On.
* 1 When projecting an input signal with 3D
timing, the keystone can only be adjusted
within ± 4 degrees.
Adjusting the LED light intensity
MENU > LED Mode
This function allows you to adjust the
brightness of the LED light source.
By changing the LED mode, you can reduce
the amount of electricity consumed and the
noise.
Select the LED Mode with the OK button,
press the / buttons to select the content,
and then press the OK button to confirm your
selection.
Press the MENU button or the BACK button.
• The default is Normal.
• The setting is saved even if you turn off the
projector.
Normal Projects at standard
brightness.
Eco Reduces the brightness of the
LED, and therefore the
amount of electricity
consumed as well as the fan
noise.