Filter
Top Products
Chapter 6 Scanning With the MultiPASS C635 6-11
Scanning
There may be times that you wish to “blow out” or “plug” a portion of
the image for effect. An example of this would be a photograph of a
piece of jewelry that contains bright reflections. These reflections are
referred to as “spectral highlights” and are usually brighter than any
other portion of the image.
❍ Click the Hilite Eye Dropper and then click on a part of the image
that is supposed to be pure white to extend the contrast of the image
to the desired level.
❍ Click the Shadow Eye Dropper to set the darkest point of the image
in the same manner as above.
❍ Click the Mid-Tone Eye Dropper on an area of the image that is as
close to neutral gray as possible.
If you make a mistake with these tools, simply repeat the process
until you are satisfied with the results.
❍ Click the Reset button to undo your changes.
❍ To manually set the balance points, click in the color boxes beneath
the eye dropper.
The standard Color Wheel appears.
❍ Click and drag around the wheel to set the desired hue and
saturation and slide the scroll bar to set the appropriate brightness.
Repeat the above procedure to manually set the mid-tone and black
points.