Canon WX450ST Projector User Manual


 
34
Preparing the Remote Control
Installing Remote Control Batteries
If buttons on the remote control are inoperative when you attempt to operate the
projector, replace the batteries with new ones.
Do not drop the remote control or subject it to impact.
Do not spill any liquids on the remote control. Doing so could damage it.
Pay attention to the following points when handling the batteries.
Failing to do so could result in a fire or personal injury.
Do not heat, short circuit or disassemble the batteries, or place
them in a fire.
Do not attempt to recharge the batteries that are included with the
remote control.
Remove the batteries when they are flat or when the remote control
will not be used for a long period of time.
When replacing the batteries, replace both at the same time. Also,
do not use two batteries of a different type at the same time.
Insert the batteries with the + and - terminals in the correct
directions.
If any liquid from inside the batteries leaks out and contacts your
skin, be sure to wash the liquid off thoroughly.
3 Close the
compartment lid.
Slide the lid until you
hear a click to
securely close it.
2 Insert batteries.
Insert 2 new AAA
batteries in the
compartment with the
+ and – poles
positioned correctly.
1 Open the battery
compartment lid.
Slide the lid while
pressing it down.