Filter
Top Products
E-31
A neck strap can be attached to the Handheld Printer Terminal to keep it from being
dropped while being carried. The stylus holder provided can also be attached.
Attach the neck strap following the
procedure described below.
Attachment Procedure
1. Pull out the neck strap mounting hooks
out of each silo on the bottom of the
Handheld Printer Terminal using the tip
of stylus. Hook the protrusive part (**)
of the ring on the neck strap mounting
hook as shown in the illustration. While
slightly pushing the ring, turn the ring
until all part of it is fully hooked.
** The ring is very stiff for the first time. A
small flat screw driver is helpful by
inserting it into overlapped part of the
ring to make a room when hooking the
protrusive part.
2. Pull back the locking bar of the neck
strap mounting hook and then hook the
mounting hook onto the ring as shown in
the illustration.
Neck strap
Adjust length here
Mounting
hooks
Stylus holder
Attaching the Neck Strap
The illustration shows the IT-3000M53E.
* ; The rings give an extra mechanical strength for
the Neck Strap. The metallic hooks of the Neck
Strap can, in rare case, be worn by abrasion
induced by swinging the IT-3000 terminal
specifically when it is hung from the operator's
neck with the Neck Strap. For those who often
use the IT-3000 terminal in a hanging position, it
is recommended to use the rings to secure the
Neck Strap.
Neck strap rings*
IT-3000_E_P16_32.p65 07.10.16, 15:1331