E-37
5. Close the roll paper holder, slide the
lock knobs on the left and right sides as
shown in the illustration to align at the
“LOCK” position to lock the roll paper
holder in position, and then tear off the
protruding roll paper.
• Please note that the positions of the
lock knobs on the left and right sides
are different.
6. Close the splash protect cover as
necessary.
• Open the splash protect cover when
printing with the printer.
• Close the splash protect cover when
using outdoors in the rain and so forth.
Important!
• Always print with the roll paper properly installed. Printing without properly
installing roll paper can damage the printer.
• If the roll paper should happen to become jammed in the printer, open the roll
paper holder by following the procedure described in steps 1 and 3 of the
procedure for “Installing the Roll Paper”, and then remove the jammed paper.
Be careful not to touch the printer at this time since it may have become hot
during the course of printing.
• The printer is not protected against splashing water when the splash protect
cover is closed with roll paper present outside the roll paper holder.
• Remove the splash protect cover when not in use. Protection against splashing
water is not guaranteed when the splash protect cover has been removed. Store
the splash protect cover in a safe location after it has been removed.
• If the end of the roll paper has become curled making it difficult to install the
paper, first flatten out the paper by bending it back in the opposite direction
before installing.
LOCK FREE
2
1
2
LOCKFREE
IT-3000_E_P33_53.p65 07.10.3, 5:37 PM37