Filter
Top Products
E-57
4. Turn on the power. This causes the Bridge Satellite Cradle power indicator lamp to
light red.
5. Place the Handheld Printer Terminal so that the infrared communication unit on the
right side is faced firmly with the infrared communication unit of the Bridge Satellite
Cradle.
• If the system is operating normally and data communication is enabled, the system
status indicator lamp lights green.
• The communication indicator lamp flashes green when data communication starts.
When charging is initiated, Indicator 1 (left side) on the Handheld Printer Terminal
lights red. When charging has been completed, it changes the color from red to green.
* The indicator may light even if the battery pack is not installed. Make sure that the
battery pack is installed when charging.
Important!
• A high-sensitivity communication element is used during IR data
communication.
In order to ensure successful communication, avoid using cellular phones or
other devices that emit radio waves in the area where you are performing IR
data communication.
If you need to use such a device, move it away from the communicating
Handheld Printer Terminals. In case of a cellular phone, keep it at least 30cm
(
11
77
77
7
⁄⁄
⁄⁄
⁄
88
88
8
") away.
• Take care to avoid allowing the Bridge Satellite Cradle power contacts to make
contact with each other since this can cause.
Shorting the power contacts can damage the Bridge Satellite Cradle.
• If you print while charging, the battery will wear down since the amount of
power discharged is greater than the amount of power supplied. Consequently,
you may not be able to print if the battery power is excessively low.
IT-3000_E_P54_77.p65 07.10.3, 5:39 PM57