Filter
Top Products
19
Initialization
TE-2200/2400 Dealer's Manual
Flag clear operation
1. Plug the power cord into an AC outlet.
2. Hold down <RECEIPT FEED>.
3. Turn the mode switch to PGM position.
4. Release <RECEIPT FEED>.
You should see “FFFFFFFFFF” on the display.
If 10 Fs are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Press <SUBTOTAL> to complete.
After completion of flag clear, receipt is issued.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
JOURNAL
FEED
Init 2 operation
After completion, receipt is issued.
1. Plug the power cord into an AC outlet.
2. Hold down <RECEIPT FEED>.
3. Turn the mode switch to PGM position.
4. Release <RECEIPT FEED>.
You should see “FFFFFFFFFF” on the display.
If 10 Fs are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Enter “8888888888” and press <CHECK TEND> to complete.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
JOURNAL
FEED
Note: After flag clear, clerk 1 is assigned automatically. So do not program clerk 1 as not assignable or
not operable in PGM mode.