Filter
Top Products
Projection Operations
49
To select the input source using remote controller keys
On the remote controller, press the [RGB], [VIDEO], or [S-VIDEO] key to select the input
source you want.
z The currently selected input source name is shown in the upper right corner of the
projection screen.
z If the currently selected input source is not sending an input signal, the message “No
signal input” appears in place of the input source name.
z Whether the displayed input source name shows [RGB] or [Component] depends on the
current “Input Settings J RGB Input” (page 89) setting that is configured on the
projector’s setup menu.
For information about configuring setup menu settings, see “Using the Setup Menu” on
page 64. For information about component video, see “Connecting to a Component Video
Output Device” on page 40.
If the input source name shows this: It means this input is selected:
RGB RGB
Component Component video