Filter
Top Products
— 70 —
ESC 3 n
[Function] Setting line feed width
[Code] <1B>H<33>H<n>
[Range] 0
n 255
[Outline] Sets the line feed width per line to [n × basic calculation pitch] .
[Caution] The line feed width can be set separately for the STANDARD
and PAGE MODES.
The basic calculation pitch currently set is used. Once defined,
the line feed width is not changed even if the basic calculation
pitch is changed.
Fractions resulting from calculation are corrected with the
minimum pitch of the mechanism, and the remainder is omitted.
• In STANDARD MODE, this command uses the basic calculation
pitch (y) in the paper feed direction.
• In PAGE MODE, this command acts differently depending on
the printing direction and the start point set with ESC T n:
(1) If the start point is specified at the top left or bottom right,
the command uses the basic calculation pitch (y) in the
paper feed direction.
(2) If the start point is specified at the top right or bottom left,
the command uses the basic calculation pitch (x) in a
direction perpendicular to the horizontal paper feed
direction.
The maximum settable line feed width is 1016 mm (40 inches).
A setting greater than this maximum is trimmed to the
maximum.
[Default] Approx 4.23 mm
[See Also] ESC 2, GS P