Filter
Top Products
16
Jack PC Hardware User Manual - Training Department
Version 0506
3.5 New Installation
Tools you will need for New Installation:
• Drill with 65 mm (2.6 Inch) Hole Saw
• Half-round File to trim wall cutout
• Cutter to remove LAN cable insulation
• Corona Punch-Down Tool to secure wires (Note: use only the tool supplied by Chip
PC – see accessories list for more details)
• Cloth to clean Housing contacts
• Screwdriver / Electric-screwdriver
• Extraction Tool to remove device after it was installed
1 Use the lower Cardboard template
supplied in packaging to mark the
designated wall cut out for the Flex-
Jack Housing installation.
2 Drill the wall cut out at the
designated location.
Warning: Make sure not to drill
next to electricity/telephone lines.
Test for existence of power lines
or enforcement beams prior to
drilling the wall cutout!
2a In case you wish to install the Jack
PC externally, you can use the Flex-
Jack External Mounting Box (Chip
PC part number CPN02172 or
CPN02173).
Insert the cable through the exiting
holes, or cut a new wire path using
one of the thinner areas.
Simply install the External Mounting
Box using standard drill and screws.