Filter
Top Products
18
Jack PC Hardware User Manual - Training Department
Version 0506
6 Close the IDC Termination
Connector Block and insert it into the
Housing bottom part until you hear a
clicking sound indicating it has
locked properly into place.
In case the Connector Block in not
locked in to position, you can slightly
bend the metal tab to create more
pressure on the Connector Block.
It is recommended to verify that
the wires are connected properly
to the Flex-Jack terminal block
before securing it in to the wall!
See chapter 6 for more
information.
6 Place the Flex-Jack Housing inside
the Jack hole. Trim wall cutout if
necessary.
7 Make sure that the Flex-Jack
Housing is fully inserted, level-
headed and that the Housing
contacts are located at the bottom
part as shown in picture.
Secure with 4 screws.
8 Gently clean the Flex-Jack Housing
contacts from dust, debris and other
objects.