Filter
Top Products
PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration 19
Configuring the 5EFL Interfaces
Note If you remove the 5EFL-equipped VIP2 from slot 3 and install it in slot 2, the addresses of
those same 10BASE-FL ports become 2/0/0 through 2/0/4 and 2/1/0 through 2/1/4.
Figure 14 10BASE-FL Interface Port Number Example (Cisco 7505 Shown)
You can identify interface ports by physically checking the slot/port adapter/interface port location
on the back of the router or by using show commands to display information about a specific
interface or all interfaces in the router.
Configuring Interfaces
The following steps describe a basic configuration. Press the Return key after each step unless
otherwise noted. At any time you can exit the privileged level and return to the user level by entering
disable at the prompt as follows:
Router# disable
Router>
Use the following procedure to perform a basic configuration:
Step 1 At the privileged-level prompt, enter configuration mode and specify that the console
terminal will be the source of the configuration subcommands, as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 2 At the prompt, specify the first interface to configure by entering the subcommand
interface, followed by the type (ethernet) and slot/port adapter/interface (interface
processor slot number). The example that follows is for the first interface of the first port
adapter, on a VIP2 in interface processor slot 1:
Router(config)# interface e 1/0/0
H6582
Slot 0
Slot 1
Slot 2
Slot 3
Interface
processor
slots
EJECT
SLOT 0
SLOT 1
NORMAL
CPU HALT
RESET
CONSOLE
ROUTE SWITCH PROCESSOR
5EFL in port adapter slot 0
(port numbers 3/0/0, 3/0/1, 3/0/2,
3/0/3, 3/0/4 from left to right)
5EFL in port adapter slot 1
(port numbers 3/1/0, 3/1/1, 3/1/2,
3/1/3, 3/1/4 from left to right)
ETHERNET-10BFL
ETHERNET-10BFL
RX
EN
TX
0
1
2
RX
TX
RX
TX
3
RX
TX
4
RX
TX
RX
EN
TX
0
1
2
RX
TX
RX
TX
3
RX
TX
4
RX
TX