Filter
Top Products
30 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
Cisco 7200 Series and the 5EFL Port Adapter
Attaching 5EFL Port Adapter Interface Cables
On a single 5EFL port adapter, you can use up to five pairs of ST fiber-optic connections. The 5EFL
port adapter is an end station device and not a repeater; you must connect the 5EFL port adapter to
a 10BASE-FL repeater or hub. ST-type fiber-optic cables are not available from Cisco Systems; they
are available from outside commercial cable vendors.
Connect ST fiber-optic cables to the 5EFL port adapter as follows:
Step 1 Attach the RX multimode fiber-optic cable directly to the RX port on the 5EFL port
adapter. (See Figure 20.)
Note Port adapters have a handle attached, but it is not shown in Figure 20 to allow a
full view of the detail on each port adapter’s faceplate.
Step 2 Attach the TX multimode fiber-optic cable directly to the TX port on the 5EFL port
adapter. (See Figure 20.)
Figure 20 Connecting 5EFL Port Adapter ST Cable Pairs
Step 3
Connect a 5EFL RX port to the appropriate TX port of the repeater, hub, DTE, or other
external 10BASE-FL equipment.
Step 4 Connect a 5EFL TX port to the appropriate RX port of the repeater, hub, DTE, or other
external 10BASE-FL equipment.
Step 5 Repeat Steps 1 and 4 for each additional 5EFL interface connection you require.
This completes cable connection to the 5EFL port adapter.
RX
ST-type optical-fiber
cables; two for each
5EFL port
To the appropriate TX and RX ports
of the repeater, hub, DTE or other
external 10BASE-FL equipment
ETHERNET-10BFL
H6770
EN
RX
0
1
2
3
4
TX
RX
TX
RX
TX
RX
TX
RX
TX
TX