Cisco UCS Cisco UCS C220 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)
CONFIGURING the SERVER
33
— Both PCIe slots (slots 1 and 2) and the mezzanine card slot are supported
— Only a single VIC card (the half-height Cisco VIC 1225 PCIe card) is supported and it
must be installed in slot 1 (the full height slot).
— Only a single Cisco UCS 3.0 TB MLC Fusion ioDrive2 card is supported and it must be
installed in slot 1 (the full height slot).
— Up to two of the other Fusion ioDrive2 cards (1205-, 785- and 365-GB versions) are
supported and can be installed in either slot 1 or 2, although an adapter may be
needed when installing one of these half-height cards in slot 1 (the full-height slot).
■ Other considerations for the Cisco VIC 1225:
— Supports 10G SFP+ optical and copper twinax connections
— The server supports installation of one Cisco VIC 1225 card and it is supported only
in PCIe slot 1.
— Requires that the server has CIMC firmware version 1.4(6) or later installed. There is
a heartbeat LED on the top of the card that indicates when firmware is active.
— To use this card for UCS integration (Cisco UCS Manager mode) with Cisco UCS
Manager 2.1(0) or later, the minimum card-firmware and uboot image level is
2.1(0.306).
■ To help ensure that your operating system is compatible with the card you have selected,
check the Hardware Compatibility List at this URL:
http://www.cisco.com/en/US/products/ps10477/prod_technical_reference_list.html