Filter
Top Products
Cisco UCS Cisco UCS C220 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)
SUPPLEMENTAL MATERIAL
69
Drive Blanking Panels
A drive blanking panel (N20-BBLKD=) must be installed if you remove a disk drive from a UCS server. These
panels are required to maintain system temperatures at safe operating levels, and to keep dust away from
system components.
Upgrading your Server from Intel Xeon E5-2600 to Intel Xeon E5-2600 v2 CPUs (or
downgrading from Intel Xeon E5-2600 v2 to Intel Xeon E5-2600 CPUs)
See the following link:
http://www.cisco.com/en/US/docs/unified_computing/ucs/hw/CPU/IVB/install/IVB-B.html
Adding an Additional CPU (with CPU heat sink)
All Cisco UCS two CPU socket-capable servers can be upgraded from having one to having two CPUs
configured. You will need to order and install a heat sink when adding any additional CPU to a server.
Instructions for installing the new CPU and heat sink can be found at the following link:
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C220/install/replace.html#wp1233864
Motherboard Lithium Battery
You can order a replacement motherboard battery. Installation instructions are found at this link:
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C220/install/replace.html#wp1235772
CPU Removal and Installation (“pick n place”) Tool Set
The Pick n Place tool set includes two tools:
■ Pick and pull cap tool - used to pull off the plastic protective cap covering an empty CPU socket and
to remove or lift a CPU processor without touching it
■ Pick and place tool - used to install a CPU in its socket without damage. Must be used each time a
CPU is installed in a UCS “M3” server.
Instructions for using this tool set are found at the following link:
2. If your server contains an LSI MegaRAID SAS 9266-8i RAID controller card with battery backup
(UCS-RAID-9266), the card contains a battery backup unit (UCS-RAID-BBU), which can be replaced. If your
server contains an LSI MegaRAID SAS 9266-8i RAID controller card without a battery backup unit
(UCS-RAID-9266NB), the card does not contain a battery backup unit (UCS-RAID-BBU); however, you can
retrofit the card with a battery backup if desired. Note that you cannot retrofit a UCS-RAID-9266NB or
UCS-RAID-9266 RAID card with an LSI Cachevault Power Module (also known as a Supercap).
3. You can order a replacement only for the RAID cards listed. You cannot retrofit a UCS-RAID-9266NB or
UCS-RAID-9266 RAID card with an LSI Cachevault Power Module (also known as a Supercap)
4. The server is shipped with the inner rail attached to the chassis.
5. This SD card is preloaded with an image specific to the C220 server.
6. This SD card is blank. The required image for the C220 server can be downloaded to the card.
7. This part is included/configured with the server chassis.
8. This part is included with the purchase of each optional or spare Intel Xeon E5-2600 CPU processor kit.
9. This part is included with the purchase of each optional or spare Intel Xeon E5-2600 v2 CPU processor kit.