Filter
Top Products
Configuring the HSSI Interfaces
PA-2H Dual-Port HSSI Port Adapter Installation and Configuration
7-10
Cisco 7200 Series and Cisco uBR7200 Series show Commands
Following is an example of how the show interfaces [type slot/port] command displays status
information (including the physical slot and port address) for the interfaces you specify. The
following example of the show interfaces hssi type slot/port command shows all of the information
specific to the PA-2H HSSI port adapter in port adapter slot 2. (Interfaces are administratively shut
down until you enable them.)
Router# show int h 2/0
Hssi2/0 is up, line protocol is up
Hardware is HSSI-B
Internet address is 2.8.1.2/24
MTU 4470 bytes, BW 45045 Kbit, DLY 200 usec, rely 252/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
Last input never, output never, output hang never
Last clearing of “show interface” counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 parity
1 input errors, 1 CRC, 0 frame, 1 overrun, 0 ignored, 0 abort
1 packets output, 24 bytes, 0 underruns
0 output errors, 0 applique, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions TM=down CA=up LC=down
Note For the Cisco 7206 and Cisco 7206VXR router shelves, the show interfaces command
requires a shelf number in the format show interfaces type shelf number/port adapter slot/interface.
Following is an example of the show controllers type slot/port command that shows information
about a specific PA-2H HSSI port adapter:
Router# show controllers hssi 2/0
(additional display text omitted from this example)
HSSI-B: show controller:
PAS unit 0, subunit 0, f/w version 2-42, rev ID 0x2800001, version 2
idb = 0x60BDE9B0, ds = 0x60BE0740, ssb=0x60BE090C
Clock mux=0x35, ucmd_ctrl=0x8, port_status=0x25
Serial config=0x8, line config=0x1B0202
maxdgram=4474, bufpool=128Kb, 256 particles
TM=down CA=up LC=down
line state: up
HSSI DTE cable, received clockrate 51838976
base0 registers=0x3D800000, base1 registers=0x3D802000
mxt_ds=0x60C34D1C, rx ring entries=128, tx ring entries=256
rxring=0x4B05FCC0, rxr shadow=0x60BE0A2C, rx_head=1
txring=0x4B060140, txr shadow=0x60BE1054, tx_head=0, tx_tail=0, tx_count=0
throttled=0, enabled=0, disabled=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=0
tx_fullring=0, tx_started=50