Filter
Top Products
Configuring the HSSI Interfaces
PA-2H Dual-Port HSSI Port Adapter Installation and Configuration
7-12
Note For complete command descriptions and examples for the Cisco 7200 series routers and
Cisco uBR7200 series routers, refer to the documentation resources listed in the “If You Need More
Information” section on page vii.
Proceed to the “Using the ping Command” section on page 7-17 to verify that each interface port is
functioning properly.
VIP2 show Commands
Following is an example of how the show interfaces [type slot/port-adapter/port] command
displays status information (including the physical slot and port address) for the interfaces you
specify. In this example, the VIP2 is in interface processor slot 1, and the PA-2H HSSI port adapter
is in port adapter slot 0. (Interfaces are administratively shut down until you enable them.)
Router# show interfaces h 1/0/0
Hssi1/0/0 is up, line protocol is up
Hardware is HSSI-B
Internet address is 5.8.1.1/24
MTU 4470 bytes, BW 45045 Kbit, DLY 200 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
Last input 2d22h, output 00:00:19, output hang never
Last clearing of “show interface” counters 2d20h
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
4084 packets output, 1298712 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Use the show version command to display the configuration of the system hardware (the number of
each interface processor type installed), the software version, the names and sources of configuration
files, and the boot images.
Following is an example of the show version command used with a Cisco 7000 series system with
an RSP7000 processor:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (RSP-JV-MZ), Version 11.1(12)CA1
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Fri 06-Oct-95 12:22 by mpo
Image text-base: 0x600088A0, data-base: 0x605A4000
ROM: System Bootstrap, Version 5.3(5)
ROM: GS Bootstrap Software (RSP-BOOT-M), Version 11.1(12), RELEASED SOFTWARE
Router uptime is 4 hours, 22 minutes
System restarted by reload
System image file is “slot0:rsp-jv-mz”, booted via slot0
cisco RSP7000 (R4600) processor with 16384K bytes of memory.
R4600 processor, Implementation 32, Revision 2.0
Last reset from power-on
G.703/E1 software, Version 1.0.