Filter
Top Products
Removing a Port Adapter
PA-FE-TX and PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
6-2
Figure 6-2 Cisco 7140 series Router—Port Adapter Slot 4 Location
Depending on your circumstances, you might need to install a new port adapter in a Cisco 7100
series router or replacea failed port adapterin the field.All portadapters available for theCisco 7100
series connect directly to the router and are locked into position by a locking tab with two screws
(see Figure 6-1 or Figure 6-2). You need a number 2 Phillips screwdriver to loosen the screws.
Note Cisco 7100 series routers support online insertion and removal (OIR); therefore, you do not
have to power down the router when removing and replacing a port adapter.
When a port adapter slot is not in use, a blank port adapter must fill the empty slot to allow the router
to conform to EMI emissions requirements and to allow proper airflow across the port adapters. If
you plan to install a new port adapter in a slot that is not in use, you must first remove a blank port
adapter.
Removing a Port Adapter
Use the following procedure to remove a port adapter from a Cisco 7100 series router:
Step 1 Attach an ESD-preventive wrist strap between you and the chassis. (See Figure 6-1 or
Figure 6-2 for the location of the ESD plug.)
Step 2 Use a number 2 Phillips screwdriver to loosen the screws on the locking tab; then slide
the tab down to the unlocked position. (See Figure 6-1 or Figure 6-2.)
Step 3 Grasp the handle on the port adapter and pull the port adapter from the router, about
halfway out of its slot. If you are removing a blank port adapter, pull the blank port
adapter completely out of the chassis slot.
Note As you disengage the port adapter from the router, OIR administratively shuts
down all active interfaces on the port adapter.
Step 4 With the port adapter halfway out of the slot, disconnect all cables from the port adapter.
Step 5 After disconnecting the cables, pull the port adapter from its chassis slot.
AC OK
DC OK
OTF
AC OK
DC OK
OTF
SLOT 0 SLOT 1
5
155 - MM
RX
RX
EN
CEL CARALM
TX
I
155 - MM
CONS
FE 0 / 0 FE
ACT
0 / 1
AUX
0
2
RX
7140 - 2MM3
RX
EN
CEL CARALM
TX
ACT
LNK
0
LNK
1
PWR
SYS
RDY
Slot 4
Unlocked
Locked
22134
ESD plug