Filter
Top Products
6-4
Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide
OL-10853-01
Chapter 6 Hardware Diagnostic Tests
About Diagnostic Tests
Step 3 Display any errors on individual components by entering the show diag post command.
SFS-7000P-1# show diag post
======================================================================
Post Status
======================================================================
fru-slot post-status post-error
----------------------------------------------------------------------
card(1) failed _FRU_LIM_CARDTYPE_ERR
card(3) failed _FRU_SEEPROM_PROGRAM_ERR
card(5) passed none
card(6) passed none
card(7) passed none
card(8) passed none
card(9) passed none
card(11) failed _FRU_POWER_CONTROLLER_CONFIG_ERR
card(12) passed none
card(13) passed none
card(15) passed none
card(16) passed none
card(17) passed none
fan(1) passed none
Running Fan Self-Test
The procedures in this section describe the fan module tests and provide sample text from performing a
fan test.
Note The sample text in the steps below shows command output for the Cisco SFS 7000P Server Switch. For
the Cisco SFS 7000D Server Switch, you would see a similar display.
To perform a diagnostic self-test on a fan, follow these steps:
Step 1 Identify the number of the fan you want to diagnose, if you do not already know the number. Power
supply 1 contains fan number 1, and power supply 2 contains fan number 2. (See Figure 6-1.)