Citizen CLP-9001 Label Maker User Manual


 
Chapter 2 Safety Precautions
4
Avoid unsafe places
Avoid unsafe places such as the top of a shaky desk, an uneven
surface or any area subject to vibration. Failure to observe this
precaution may cause the printer to fall or turn over, resulting in injury.
Dot not put water-filled containers nearby
Do not put containers filled with water or chemical liquids such as
vases and cups near the printer. If a liquid spills or enters the printer,
turn off the power switch immediately, remove the plug of the power
cord from the outlet, and contact our service personnel. Continued use
without corrective action may result in fire or electrical shock.
Do not allow any foreign matter to enter
Do not allow any metallic objects or flammable material to enter or fall
into the printer through the openings (such as the cable port). If foreign
matter enters, turn off the power switch immediately, remove the plug
of the power cord from the outlet, and contact our service personnel.
Continued use without corrective action may result in fire or electrical
shock.
Do not use an improper power voltage
Do not use a power voltage other than the specified in the rating label
on the rear of the printer. Failure to observe this precaution may result
in fire or electrical shock.
Connect the ground wire
Make sure that the ground wire to the printer is properly connected to
the earth. Failure to do so may result in electrical shock.
WARNING