Filter
Top Products
Chapter 6 Configuring Your Printer Using The Menus
−
47
−
Group Menu Menu Item Default Range Description
Cutter Type Standard Standard
HeavyDty
Select cutter type. (“Cutter Type” is
shown when the optional device is
installed.)
Cutter Action Backfeed Backfeed
Through
Set media feed direction. (“Cutter Action”
is shown when peeler unit is installed.)
Backfeed: Always back feed media to
top-of form after cutting operation.
Through: Media stays present position
after cutting operation.
Paper Position 0.00IN
0.00mm
Function Off
0.00 − 2.00 in
0.0 − 50.8 mm
Function Tear or
PeelWait or Cut:
- 1.00 − +1.00 in
- 25.4 − +25.4 mm
Adjust media (paper) position for default
media position.
Selected value will be 0.00 in (0.00 mm)
automatically if “Function Select” is
changed.
Rewinder Torque 4 1-5 Set rewinder torque. (“Rewinder Torque”
is shown when peeler unit is installed.)
* After Print
Repeat Button LabelSet LabelSet
LastOne
Disabled
Enable or disable print label set with
REPEAT key pressed.
LastSet: Print next label set.
LastOne: Print one label to be followed
by the next label set.
Disabled: Disable print label set.
RS-232C Baud 115200 115200
600
1200
2400
4800
9600
14400
19200
38400
57600
Set serial interface baud rate.
New value is valid after power is turned
off and on gain or a reset command is
issued.
RS-232C Parity None None
Odd
Even
Set serial interface communication
parity.
RS-232C Length 8 bits 8 bits
7 bits
Set serial interface character length.
RS-232C Stop bit 1 bit 1 bit
2 bits
Set serial interface stop bits.
* Interface
RS-232C X-ON Yes No
Yes
Enable or disable serial interface X-ON
flow control.
* Save Settings
Permanently save configuration values
in non-volatile memory.
(continued)