Filter
Top Products
iDP-3210 User’s Manual
62/67 CITIZEN
(38) Data Input Control (ESC = n)
Code : [1B]h + [3D]h + n
* {0 is less than or equal to n is less than or equal to FF} Data is described in Hex code.
Selecting equipment in which data input from the host is effective.
• Each bit of n indicates as follows:
VALUE
BIT EQUIPMENT 0 1
0 Printer Invalid Valid
1 Not defined
2 Not defined
3 Not defined
4 Not defined
5 Not defined
6 Not defined
7 Not defined
• When the printer has not been selected, this printer abandons all received data until it
is selected by this command.
• Even when the printer has not been selected, it can become BUSY state through printer
operation.
• The initial value of n is "1".
(39) Aligning the characters (ESC a n)
Code : [1b]h + [61]h + n
* {0 is less than or equal to n is less than or equal to 2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
• Depending on n value, positional alignment is carried out as in the table below:
n (Hex) POSITION
0 Left end alignment
1 Centering
2 Right end alignment
• This is valid only when n is inputted at the beginning of line.
• The initial value of n is "0".
(40) Full Cut (ESC i)
Code : [1B]h + [69]h
Full cutting of paper is performed.
• This is valid only when n is inputted at the beginning of line.
(41) Partial Cut (ESC m)
Code : [1B]h + [6D]h
Partial cutting of paper is carried out.
• This is valid only when n is inputted at the beginning of line.
idp-3210 User's Manual