Filter
Top Products
- 69 -
GS $ nL nH
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Specifying the absolute position of character vertical direction in PAGE MODE
[Code] <1D>H<24>H<nL><nH>
[Range] 0≦nL≦255、0≦nH≦255
[Outline] [The specification which is common to the model]
Specifies the vertical position of character at the start point of data development in PAGE MODE
using absolute position based on the start position. The position of vertical direction of character at
the start position of next data development is the position [(nL+nH×256)×basic calculation pitch]
from the start position.
[Caution] • This command is ignored except at PAGE MODE selection.
• Absolute position setting exceeding the specified print area is ignored.
• Position in horizontal direction of character at the start position of data development is not shifted.
• Start point used as the reference is set by ESC T.
• The following operation occurs at the start point of ESC T.
(1) When start point is set at “upper left” or “lower right”, the absolute position of paper feed
direction (vertical direction of character) is set. In this case, basic calculation pitch (y) of
vertical direction is used.
(2) When start point is set at “upper right” or “lower left”, the absolute position of vertical
direction of paper feed (vertical direction of character) is set. In this case, basic calculation
pitch (x) of horizontal direction is used.
• Basic calculation pitch is set by GS P.
• When fractional number is caused by the calculation, it is corrected by the minimum pitch of
mechanism and the rest is discarded.
[See Also] ESC $, ESC T, ESC W, ESC
＼
, GS P, GS
＼