Citizen Systems CT-S310 Printer User Manual


 
- 93 -
GS r n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Sending status
[Code] <1D>H<72>H<n>
[Range] CT-S280/BD2-2220/PMU2XXX
n=149
CT-S300/CT-S2000/CT-S4000/CT-S310
1n249n50
[Outline] [The specification which is common to the model]
Sends the specified status to the host.
n Function
1,49 Sends the Paper Sensor status.
2,50 Sends the Drawer Kick-out Connector status.
[Caution] [The specification which is common to the model]
• When the serial interface is used:
For DTR/DSR control:
The printer sends the status after verifying that the host is ready to receive. If the host is not
ready to receive, the printer waits for the host to become ready to receive.
For XON/XOFF control:
The printer sends the status without checking whether the host is ready to receive or busy.
• Because this command is executed when data is mapped in the receive buffer, there may be a
delay between receiving the command and sending the status depending on the condition of the
receive buffer.
• If ASB (Automatic Status Back) is enabled by GS a, the host must discriminate between the status
due to this command and the status due to ASB.
• Whenever the Paper-end Sensor detects a “paper out” state, the printer goes offline, and the
command is not executed. Therefore, the printer never sends a status “No paper in Paper-end
detector (0CH)”.
[The specification which depend on the model]
CT-S280/BD2-2220/ PMU2XXX
• At the setting of MSW3-7 OFF, paper sensor status is fixed to 00h.