Filter
Top Products
- 73 -
GS
＼
nL nH
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Specifying the relative vertical position of a character in PAGE MODE
[Code] <1D>H<5C>H<nL><nH>
[Range] 0≦nL≦255、0≦nH≦255
[Outline] [The specification which is common to the model]
This command is used in PAGE MODE to specify the vertical position of a character in the data
mapping start position, in a relative position with respect to the current position. The next data
mapping start position will be at a point [(nL+nH×256)×basic calculation pitch] inches away from
the current position.
[Caution] • This command is ignored when PAGE MODE is not selected.
• If a new position is specified for a character located beneath the current position, it should be
specified as positive (+). If it is above the current position, it should be negative (–).
• A negative value is the complement of 65536. For example, to move the position by N pitches up,
specify it as: nL + nH x 256 = 65536 – N
• The specification of a relative position outside the specified print area is ignored.
• Depending on the start point specified by ESC T, this command acts as follows:
(1) If the start point is the top left or bottom right, the command specifies the relative position in
the paper feed direction (the character’s top-bottom direction) using the vertical basic
calculation pitch (y).
(2) If the start point is the top right or bottom left, the command specifies the relative position in
the direction perpendicular to the paper feed (the character’s top-bottom direction) using the
horizontal basic calculation pitch (x).
• The basic calculation pitch is set by GS P.
• Fractions resulting from calculations are corrected with the minimum pitch of the mechanism, and
the remainder is omitted.