Compaq 230934-002 Switch User Manual


 
Initial Configuration of the Switch
2-4 Modular SAN Array Fabric Switch 6 User Guide
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: c-ch2 Initial Configuration of the Switch.doc
Codename: Millebourne Part Number: 230934-002 Last Saved On: 7/17/02 7:46 AM
5. Set up the properties for the terminal connection.
In Windows NT 4.0:
a. Double-click the Hypertrm icon.
b. Enter a name for the connection in the New Connection dialog box, select an
icon to represent the switch for future use, and click OK.
The Connect To dialog box is displayed.
6. From the Connect using drop-down menu, select the communications port
assigned to the serial port (for example, COM1, COM2) and click OK. In the
properties dialog box, enter the following port settings and select OK.
Table 2-1: Default Serial Port Settings
Type Setting
Bits per second (baud rate) 38,600
Data bits 8
Parity None
Stop bits 1
Flow control None
7. Select FileProperties to show the connection properties dialog box. Select the
Settings tab. From the Emulation pull-down menu, select VT100 and click OK.
8. Power ON all peripheral device(s).
9. Wait at least ten seconds and power cycle the MSA1000. The switch sends a
series of Power-on Self-Test (POST) messages in HyperTerminal.