Filter
Top Products
Optional
23
Optional
Additional settings, like routing entries, can be configured. This allows
communications across subnets.
Configuration of the PrintNet can be done from the printer control panel,
IPAssign, Web browser, or host commands.
Configuration Using the Control Panel
You can set any of three listed parameters from the printer control panel.
These parameters are located in the Ethernet™ Parameters menu. The
available parameters are:
• IP Address
• Gateway Address
• Subnet Mask
The procedure for changing any of the parameters is the same. The
procedure for changing the IP Address is given here as an example. Use
the same procedure for the other required parameters. To change the IP
Address parameter:
1. Make sure the printer is on and raise the printer cover.
2. Press the ONLINE key to place the printer in the OFFLINE mode.
3. Unlock the ENTER key. Refer to the
User’s Manual
for instructions.
4. Press the LEFT or RIGHT arrow key until the LCD displays
“ETHERNET PARAMS.”
5. Press the DOWN arrow key to access the “IP Address” parameter.
6. Press the DOWN arrow key to view the current IP Address.
7. Press the DOWN arrow key to access the portion of the IP Address to
be changed.
8. Press the LEFT or RIGHT arrow key to select the portion of the IP
Address to be changed.
9. Press the DOWN arrow key.
10. Press the LEFT or RIGHT arrow key to select the desired value.