Filter
Top Products
Chapter 6 Configuring the PrintNet Interface TCP/IP Settings
82
Mandatory Settings
The PrintNet Interface must be configured with an IP address and subnet
mask at a minimum. Consult you network administrator to obtain the
proper values for these parameters.
Optional Settings
One additional setting, the gateway address, is necessary if the OS/2
workstations must communicate with the PrintNet Interface across a
router. Consult your network administrator to obtain the proper value for
this parameter.
Configuration using the Printer Operator Panel
You can set any of three listed parameters from the control panel. These
parameters are located in the Ethernet Parameters menu. The available
parameters are:
• IP Address
• Gateway Address
• Subnet Mask
The procedure for changing any of the parameters is the same. The
procedure for changing the IP Address is given here as an example. Use
the same procedure for the other required parameters. To change the IP
Address parameter:
1. Make sure the printer is on and raise the printer cover.
2. Press the ON LINE key to place the printer in the OFFLINE mode.
3. Unlock the ENTER key. Refer to your printer’s
User’s Manual
for
instructions.
4. Press the LEFT or RIGHT arrow key until the LCD displays
“ETHERNET PARAMS.”
5. Press the DOWN arrow key to access the “IP Address” parameter.
6. Press the DOWN arrow key to view the current IP Address.