Filter
Top Products
Chapter 6 OS/2 Workstation Configuration
88
9. At the system prompt, enter:
store tcpip from default
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and reset the
PrintNet.
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway parameters to
the desired values.
12. If Web browser access does not work, Telnet into the PrintNet as
root. Enter the following command:
config http on
If you are still experiencing difficulty accessing or browsing the printer,
contact technical support for further assistance.