Filter
Top Products
Setup Utility (Intel Pentium 4 Models)
Change Supervisor Password Screen
The Change Supervisor Password screen is used to change the
supervisor password. The default setting is no password. Once a
password is set, a user must enter the password to change parameters
using the Setup Utility.
Enter the new supervisor password in the dialog box, and then press
the
Enter key.
To remove or disable the set password, enter the current password,
then press
Enter when prompted to enter a new password.
Clearing CMOS clears the Power-On Password. It does NOT clear
the Supervisor Password.
You can configure the system to use the same password for both
power up and Setup utility entry. To do this, use the Advanced
CMOS Setup menu option, highlight Password Check, and then
select the Always option.
Clearing passwords clears both the Supervisor and Power-On
Passwords, but does not clear the Always option. To reset only the
Supervisor Password, change Always to Setup on the Available
Options list.
Auto Configuration with Optimal Settings Screen
The Auto Configuration with Optimal Settings screen is used to load
configuration settings that give the highest performance to the
system. The system is shipped with these settings as the default. Use
this option to return the system to optimal performance.
To load the high performance configuration settings, choose Y when
prompted by the dialog box, and then press the
Enter key.
3-10 Compaq Evo D300v User’s Guide