Using the System Control Manager 8-15
Table 8–1 SCM Commands (Continued)
Command Description
Set modem_baud
Sets the modem baud rate.
Set dial Sets the string to be used by the SCM to dial out
when an alert condition occurs.
Set local_baud Sets the baud rate of the SCM-to-local console
device UART.
Set com1_baud
Sets the baud rate to the SCM-to-system UART.
Set hp_count
Defines the number of hard partitions in system.
Set hp_qbb_maskx Sets a value that creates a binary mask in which a
bit set to 1 indicates that a QBB belongs to a
partition x.
Set init Assigns the modem initialization string
appropriate for the dial-out modem at the system
site.
Set password Defines the password to be used by the remote
user when dialing into the system.
Show csb Displays a list of all known nodes on the console
serial bus.
Show fru Displays information on field-replaceable units
(FRUs).
Show nvr Displays additional nonvolatile environment
variables.
Show status
Displays SCM status and information.
Show system Displays an overall system summary, including
the most recent system self-test results and the
current temperature and voltage readings.
Test alert Tests the modem setup and connection to the
remote pager or computer.