Filter
Top Products
Using the System Control Manager 8-25
Enables remote access to the SCM modem port.
Sets the password (in the example, “wffirmare”) that is prompted for at the
beginning of a modem session. The string cannot exceed 14 characters and
is not case sensitive. For security, the password is not echoed on the
screen. When prompted for verification, type the password again.
Sets the modem initialization string. The string is limited to 31 characters
and can be modified depending on the type of modem used.
The SCM automatically configures the modem's flow control according to
the setting of the SRM com1_flow environment variable. The SCM also
enables the modem carrier detect feature to monitor the modem
connectivity.
After the initialization string is set, it is copied to the SCM’s EEPROM to
allow the SCM to reinitialize the modem in the case of a system power
cycle.
The init command is entered to initialize the modem.
At this point, the modem is configured for remote dial-in.
Dialing In
Once the remote session is connected, the password must be entered to access
the SCM CLI. The following example shows the screen output when a modem
connection is established.
atdt915085551212
CONNECT 9600
Password: **********
Access granted
Modem escape sequence verified
SCM_E0>
1. At the SCM_E0> prompt, enter SCM CLI commands to monitor and control
the system. Use the show status command to check the current manage-
ment settings and the channel the modem connection is currently using.
2. When you have finished a modem session, enter the hangup command to
cleanly terminate the session and disconnect from the server.