Filter
Top Products
5–40 Maintenance and Service Guide
Removal and Replacement Procedures
✎
Make sure the docking stand and pivot arm are supported before
removing the following screws. The docking stand and pivot arm
can fall if not supported.
7. Remove the following screws:
❏
Two PM2.5 × 5.0 screws
1
that secure the cable bracket
to the bottom case (Figure 5-33)
❏
One PM2.5 × 12.0 screw
2
that secures the pivot arm
hinge to the bottom case
❏
Three PM2.5 × 6.0 screws
3
that secure the pivot arm
hinge to the bottom case
8. Remove the docking stand and pivot arm
4
.
Figure 5-33. Removing the Docking Stand and Pivot Arm