Filter
Top Products
DS2400 DATALOGIC
1.2 -
General Features
•
completely configurable via serial interface (WinHost
).
•
2 serial communication interfaces.
•
supply voltage from 10 to 30 Vdc.
•
reads all popular codes.
•
test mode to verify the reading features and exact positioning of the
scanner without the need for external tools.
•
programmable in 4 different operating modes to suit the most various
barcode reading system requirements.
•
code verifier.
The DS2400 uses a solid state laser diode as a light source; the light emitted
has a wavelength between 630 and 680 nm. Refer to the section “Safety
precautions” at the beginning of this manual for information on laser safety.
The protection class of the enclosure is IP65, the reader is therefore suitable
for industrial environments where high protection against harsh external
conditions is required.
The four LEDs on the side of the scanner indicate the following:
PWR/TXD
LED (red) (Figure A,
1
) indicates the reader is connected
to the power supply or, when blinking (green), data
transmission.
GOOD READ
LED (red) (Figure A,
3
) is used to signal the possibility of a
successful barcode reading.
EXT TRIG
LED (yellow) (Figure A,
2
) indicates external trigger
activity. Refer to par. 2.4.4.
LASER ON
LED (green) (Figure A,
4
) indicates laser ON state.
The screw holes on the body of the reader are for mechanical fixture (Figure
A,
8
).