Filter
Top Products
DS2400 DATALOGIC
2.12
- Installation
DS2400
TX485+
2
TX485-
4
RX485+
3
RX485
RX485-
5
TX485
7
SGND
SGND
USER INTERFACE
+
-
+
-
+
Figure 2.14 - RS485 full-duplex connections
RS485 Half-Duplex Interface
The RS485 half-duplex (3 wires + shield) interface is used for polled
communication protocols.
It can be used in a master/slave layout or for Multidrop connections with a
Datalogic Multiplexer, (see par. 2.6.4 and 2.6.5).
The connector pinout follows:
Pin Name Function
2 RTX485+ RS485 transmitted/received data +
4 RTX485- RS485 transmitted/received data -
7 SGND Signal Ground
RTX485 +
2
RTX485 -
4
RTX485 +
RTX485 -
7
SGND
MULTIPLEXER
RS485REF
DS2400
Figure 2.15 - RS485 half-duplex connections
This interface is forced by software when the protocol selected is MUX32
protocol.
In a Multiplexer layout or for slaves, the Multidrop address must also be set
via serial channel by the WinHost utility or by ESC sequences.