Filter
Top Products
viii
Warning labels indicating exposure to laser light and the device classification
are applied onto the body of the
scanner (Figure A,
5
).
Warning and device class labels
Disconnect the power supply when opening the
device during maintenance or installation to avoid
exposure to hazardous laser light.
The laser diode used in this device is
classified as a class 3B laser product
according to IEC 825-1 regulations and as
a Class IIIb laser product according to
CDRH regulations. As it is not possible to
apply a classification label on the laser
diode used in this device, the following
label is reproduced on the right.
Any violation of the optic parts in particular can cause radiation up to the
maximum level of the laser diode (7 mW at 630 to 680 nm).
POWER SUPPLY
- This product is intended to be installed by Qualified Personnel only.
- Models DS2400-XXX0:
This accessory device is intended to be supplied by a UL Listed Power Unit
with «Class 2» or LPS power source which supplies power directly to the
scanner via the 25-pin connector.
- Model DS2400-XXX1:
This accessory device is intended to be supplied via the Junction Box by an
NEC Class 2 Power Source rated 10-30 V, minimum 0.55 A.
CAUTION - LASER LIGHT WHEN OPEN
AVOID EXPOSURE TO BEAM
LISTED
ACCESSORY
45AF
I.T.E.
This product conforms to the applicable
requirements of 21CFR1040 at the
date of manufacture.
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO IEC 825-1 (1993)
R
R
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAX. OUTPUT RADIATION 7 mW
EMITTED WAVE LENGTH 630~680 nm
TO IEC 825-1 (1993)
Laser diode class label