Filter
Top Products
18 E-3202 Printer
4.4 Connecting to an ESC POS Terminal
The default configuration of your printer is Windows/Epson 24 pin. You
will have to change the emulation type to ESC POS to work with your
ESC POS Terminal. Check your Terminal communication parameters
and change the printer settings to match your terminal settings.
Default Communication parameters
Speed: 57600 baud
Data: 8 bits
Parity: None
Control: Hardware
To check the current emulation and communication parameters of your
printer:
1. Make sure that a roll of paper is loaded, (not label media).
2. Set the printer to the Off line mode.
3. Press both buttons simultaneously until the configuration is printed.
If the configuration is not correct see section 4.4 Changing the Default
Settings.