Filter
Top Products
dCS 974 User Manual Manual for Software Version 1.0x
dCS Ltd May 2001
Manual part no: DOC1241121A1
Page 110
Document No: OS-MA-A0124-112.1A1
Contact
dCS
on + 44 1799 531 999 email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
U
SING
Y
OUR
dCS 974
F
OR
T
HE
F
IRST
T
IME
What’s in the Box?
The contents of the box are at least:
dCS 974
User Manual
Quick Start Guide
Power cable
2 Spare Fuses
Remote cable
Remote software
Supply Voltage Setting
The dCS 974 is shipped with its supply voltage preset for operation in the
destination country. The voltage is not intended to be changed by the user. If it
needs to be changed, see the section Having Your Options Changed on page
114.
Getting Started
Here’s what to do:
(If the unit does not behave the first time you power up – contact your re-seller
or dCS.)
do this: Check the appropriate mains supply for your local mains is marked on the rear
panel.
do this: If it is, connect the unit to a power outlet using the cable supplied - connect no
other leads at this stage - and switch on. The Power LED will light, then the
screen will light up and display:
After approximately 20 seconds, the front panel LEDs will indicate the last
stored state and the Unlocked LED will light. The screen will then display the
Status Screen, for example:
do this: Connect a signal source to an appropriate input: AES 1, 2, 3 or 4, SPDIF1, 2 or
3 or SDIF-2 CH1 IN, CH2 IN & WCLK IN.
We recommend an AES3 source into the AES 1 input until you are comfortable
with the unit. The procedure below assumes you have connected your source to
the AES 1 input.