Filter
Top Products
Back to Contents Page
Palm Rest
Dell™Vostro™1700andInspiron™1720/1721ServiceManual
Removing the Palm Rest
Replacing the Palm Rest
Removing the Palm Rest
1. Follow the instructions in Before You Begin.
2. Remove the optical drive (see Removing the Optical Drive).
3. Remove the hard drive (see Removing a Hard Drive).
4. Remove the hinge cover (see Removing the Hinge Cover).
5. Remove the keyboard (see Removing the Keyboard).
6. Remove the display assembly (see Removing the Display Assembly).
7. Remove the internal card with Bluetooth wireless technology, if installed (see Removing the Bluetooth Card).
8. Remove the sixteen M2.5 x 8-mm screws from the bottom of the computer.
9. Turn the computer over and remove the six M2.0 x 3-mm screws that secure the top of the palm rest.
10. Disconnect the touch pad connector from the system board.
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTE: It is not necessary to remove the Bluetooth cable connector from the system board connector.
NOTE: The screw locations may vary slightly from the image shown below.