Dell 1900 Laptop User Manual


 
Troubleshooting Your System 113
20
Close the system. See "Closing the System" on page 48.
21
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
22
Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
23
Repeat step 17 through step 22 until all expansion cards are reinstalled or one of the expansion cards
causes the tests to fail.
If the problem is not resolved,
see "Getting Help" on page 131.
Troubleshooting an Optical Drive
Problem
System cannot read data from a CD or DVD in an optical drive.
Optical drive indicator does not blink during boot.
Action
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1
Remove the bezel. See "Removing the Bezel" on page 46.
2
Try using a different CD or DVD that you know works properly.
3
Enter the System Setup program and ensure that the drive’s IDE controller is enabled. See "Using the
System Setup Program" on page 33.
4
Run the appropriate online diagnostic test. See "Using Server Administrator Diagnostics" on page 121.
5
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
6
Open the system. See "Opening the System" on page 48.
7
Ensure that the interface cable is securely connected to the optical drive and to the controller.
8
Ensure that a power cable is properly connected to the drive.
9
Close the system. See "Closing the System" on page 48.
10
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
If the problem is not resolved,
see "Getting Help" on page 131.
Troubleshooting an External SCSI Tape Drive
Problem
Defective tape drive
Defective tape cartridge