Filter
Top Products
Installing System Components 75
5
To remove the diskette drive filler plate, pull the retention spring slightly away from the filler plate,
then lift the filler plate from the carrier.
6
Install the diskette drive carrier into the system:
a
Align the slots on the bottom of the diskette drive carrier with the drive bay tabs on top of the
peripheral bay and lower the carrier unto the tabs.
b
Push the carrier toward the system front plate until the plastic latch on the carrier locks into
position.
7
Attach one end of the ribbon cable to the floppy connector (FLOPPY) on the system board
(Figure 6-2) and the other end to the connector on the rear of the diskette drive.
8 Attach power cable P4 from the power supply to the power connector on the rear of the diskette
drive.
9
If applicable, replace the components your removed in step 4:
a Replace the center fan bracket. See
"Replacing the Center Fan Bracket" on page 79
.
b
Replace the fans into the center fan bracket. See "Removing and Installing a Fan" on page 53
c
If applicable, reconnect the cables to the SAS controller card (see Figure 3-13) or the SAS RAID
controller daughter card (see Figure 3-14).
10 Close the system. See
"Closing the System" on page 48
.
11 Replace the front bezel, if removed. See "Installing the Bezel" on page 47.
12
Reconnect the system and peripherals to their electrical outlets.
System Battery
Replacing the System Battery
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Enter the System Setup program and record the option settings on the System Setup screens. See
"Using the System Setup Program" on page 33
.
2
Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
3 Open the system. See
"Opening the System" on page 48
.
4
See Figure 6-2 for the location of the system battery and then, st
arting with PCI slot 6, remove as
many expansion cards as you need to create enough room in the expansion bay to work with the
system battery.
See "Removing an Expansion Card" on page 58.