Filter
Top Products
108 Troubleshooting Your System
d
Close the system. See "Opening and Closing the System" on page 48.
e
Run the appropriate diagnostic test.
If the tests fail,
see "Getting Help" on page 125.
Troubleshooting the Microprocessors
Problem
• Error message indicates a processor problem.
• Front-panel status LCD indicates a problem with the processors or system board.
• A heat sink is not installed for each processor.
Action
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1
Run the appropriate online diagnostics test. See "Using Server Administrator Diagnostics" on page 111.
2
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
3
Open the system. See "Opening and Closing the System" on page 48.
4
Ensure that each processor and heat sink are properly installed. See "Removing the Processor" on
page 67.
5
Close the system. See "Opening and Closing the System" on page 48.
6
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
7
Run the appropriate online diagnostic test.
If the tests fail or the problem persists, continue to the next step.
8
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
9
Open the system. See "Opening and Closing the System" on page 48.
10
Remove processor 2, leaving only processor 1 installed. See "Removing the Processor" on page 67.
If only one processor is installed,
see "Getting Help" on page 125.
11
Close the system. See "Opening and Closing the System" on page 48.
12
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
13
Run the appropriate online diagnostic test.
If the tests complete successfully, go to step 19.
14
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.