Filter
Top Products
Installing System Components 71
RAC Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
The optional Remote Access Controller (RAC) provides a set of advanced features for managing the
server remotely. The following procedure describes the steps for installing the optional RAC card.
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2
Open the system. See "Opening and Closing the System" on page 48
3
Remove the plastic filler plug from the system back panel. See Figure 3-16.
4
Remove the center riser card from the system board. See "Expansion-Card Riser" on page 81.
5
Angle the RAC card so that its NIC connector inserts through the back-panel RAC card opening,
aligning the card with the back standoff.
Figure 3-16. Installing a RAC Card
6
Align the front edge of the RAC card with the front plastic retention standoffs, and press down the
front of the card until it is fully seated. See Figure 3-16.
1 RAC card 2 RAC-card connectors (2) 3 filler plug location
4 back standoff 5 front standoffs (2) 6 RAC-card cable connectors
1
4
5
6
2
3