Filter
Top Products
From this
menu:
You can:
Receive information at a much higher transmission rate if the printer is set
to Fastbytes (if computer supports Fastbytes), or receive information at a
normal transmission rate if the printer is set to Standard.
Standard
Fastbytes*
Honor Init Determine whether the printer honors hardware initialization requests from
the computer. The computer requests initialization by activating the INIT
signal on the parallel interface.
Many personal computers activate the INIT signal each time the computer is
turned on and off.
On
Off*
Parallel
Mode 2
Determine whether the parallel port data is sampled on the leading (on) or
trailing (off) edge of the strobe.
Off
On*
NOTE: This menu appears only if supported by the parallel port.
MAC Binary
PS
Configure the printer to process Macintosh binary PostScript emulation print
jobs.
Off
On
Auto*
Parallel With
ENA
ENA
Address
ENA
Netmask
ENA
Gateway
Configure the parallel port ENA address, Netmask, and Gateway settings.
4 field IP address (0.0.0.0*)
NOTE: These settings are shown only when ENA is attached through the
parallel port.
* Factory default setting
Settings
Mode Mode Main Menu
Settings General Settings
Setup Menu
Finishing Menu
Receive information at a much higher transmission rate if the printer is set
to Fastbytes (if computer supports Fastbytes), or receive information at a
normal transmission rate if the printer is set to Standard.
Standard
Fastbytes*
Honor Init
Determine whether the printer honors hardware initialization requests from
the computer. The computer requests initialization by activating the INIT
signal on the parallel interface.
Many personal computers activate the INIT signal each time the computer is
turned on and off.
On
Off*
Parallel
Mode 2
Determine whether the parallel port data is sampled on the leading (on) or
trailing (off) edge of the strobe.
Off
On*
NOTE: This menu appears only if supported by the parallel port.
MAC Binary
PS
Configure the printer to process Macintosh binary PostScript emulation print
jobs.
Off
On
Auto*
Parallel With
ENA
ENA
Address
ENA
Netmask
ENA
Gateway
Configure the parallel port ENA address, Netmask, and Gateway settings.
4 field IP address (0.0.0.0*)
NOTE: These settings are shown only when ENA is attached through the
parallel port.
* Factory default setting
Settings
Mode
Mode Main Menu
Settings
General Settings
Setup Menu