Filter
Top Products
80 Removing and Installing Parts
9
If you removed a sound card:
a
Enter system setup (see "System Setup" on page 107), select
Audio Controller
, and then change
the setting to
On
.
b
Connect external audio devices to the audio connectors on the back panel of the computer.
10
If you removed an add-in network connector:
a
Enter system setup (see "System Setup" on page 107), select
Integrated NIC
, and then change the
setting to
On
.
b
Connect the network cable to the integrated connector on the back panel of the computer.
11
Install any drivers required for the card as described in the card documentation.
Drive Panel
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
Removing the Drive Panel
1
Follow the procedures in "Before You Begin" on page 59.
drive panel
sliding plate
sliding plate lever
WD846bk2.book Page 80 Thursday, September 14, 2006 2:40 PM