Filter
Top Products
80 Configuration: About Your Storage Array
Changing the Enclosure Order in the Physical Pane
You can change the order of the RAID controller modules and the expansion
enclosures in the Physical pane to match the hardware configuration in your
storage array. The Physical pane that initially is displayed is a default view
that may not match your storage array. The enclosure order change remains in
effect until it is modified again.
To change the enclosure order in the Physical pane:
1
In the AMW, select
Storage Array
Change
Enclosure Order
.
2
From the
Enclosures list,
select the enclosure you want to move and click
either
Up
or
Down
to move the enclosure to the new position.
3
Click
OK
.
If you have set a password for the selected storage array, the
Enter
Password
dialog is displayed.
4
Type the current password for the storage array.
5
Click
OK
.
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1
In the EMW, select the
Setup
tab.
2
Select
Configure Alerts
.
The
Configure Alerts
dialog is displayed.
3
Select
All storage arrays
.
4
Click
OK
.
The
Configure Alerts
dialog is displayed. To configure e-mail alerts, see
"Configuring E–mail Alerts" on page 81. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 83.
book.book Page 80 Tuesday, June 18, 2013 3:03 PM