Filter
Top Products
7
Mounting and Commissioning
Mounting and Installation Sequence
The Eumex 704PC LAN consists of various components. This User Guide first
describes how to mount the communications system and how to connect terminals
such as telephones. You can subsequently operate the devices.
However, we recommend that you configure the Eumex 704PC LAN according to your
personal requirements before using it for the first time. You can configure the system
via a telephone or use a menu-driven configuration program on a connected PC.
Please proceed as follows:
1. Mount the Eumex 704PC LAN and connect the devices as described in the follow-
ing sections.
2. Configure the communications system. You can do this in three different ways
• PC configuration: menu-driven configuration via a PC. In order to do this, all the
drivers on the CD supplied must be installed. Please refer to the chapter entitled
"Installing the Software" on p. 60 for instructions on how to do this.
• Configuration via a telephone connected to your communications system.
Please refer to the chapter entitled "Configuration via Telephone" for instructions
on how to do this.
• Remote configuration: you can have your system remotely configured by Tele-
Service for a fee.
For remote configuration, call: 0180 2 55 66 55.
PC configuration:
3. Install the CAPI driver. This procedure is described in the chapter entitled "The PC
Software" on p. 57 ff.
4. Install and configure the Teledat RVS-COM communications software as described
in the chapter entitled "Teledat RVS-COM" on p. 83.
With regard to points 2, 3 and 4 above, please note the system prerequisites listed in
the section entitled "What Does the Eumex 704PC LAN Require?"
Using the Web Configurator you can also configure the system from other operating
system platforms. For more information, please refer to "The Web Configurator" on
p. 90 ff.
In the Appendix you will find a glossary, an index of key words, and a diagram of the
Eumex 704PC LAN audio signals and ringer cadences.