Filter
Top Products
9
Mounting and Commissioning
Connect the Eumex 704PC LAN to a separate 230 V
~
mains circuit. This prevents
the communications system from being affected by possible short circuits in any
other household equipment.
We recommend you to install a surge protector for protection against sudden high
voltages such as those sometimes occurring during thunderstorms. Consult your
electrician or Deutsche Telekom for advice.
Wall Mounting
Tools for Wall Mounting
Choosing a Location for Your Eumex 704PC LAN
You can simply place the Eumex 704PC LAN on a solid surface, e.g. a table. Please
note that under certain circumstances the rubber pads on the base of the Eumex
704PC LAN can leave unseemly marks on furniture.
You will require the following tools for wall mounting:
• 6 mm masonry drill bit (the type of drill bit depends on the type of wall)
• Hammer or percussion drill
• Screwdriver (to fit the screws supplied)
Get the rawlplugs, screws and drilling template (all supplied) ready before you start
mounting the device.
Make sure that there are no pipes, cables or similar objects running through the wall
near the planned drill holes, as these could be damaged.
Use the drilling template supplied and a 6-mm bit to drill holes for the two mounting
screws 180 mm apart.
Insert the rawlplugs and screw the screws into the wall so that a space of 4 mm
between the head of the screw and the wall remains.
Place the mounting holes in the base of the Eumex 704PC LAN over the screws, and
pull downwards slightly.
a