Filter
Top Products
Chapter 4: Using Utility to Setup IP & Update Firmware
Choose this if you do not know your basic Network Configurations
“Use the following IP Address”
Enter an appropriate internal IP Address, Subnet Mask and Gateway for IP
Camera (Refer to Appendix C for an explanation of IP Addresses)
“Obtain an IP address by Bootp”
Allow IP Camera to obtain an IP address using Bootp protocol.
6. Click “Next >” to proceed to xDSL/Cable modem setup.
This section has to be configured to allow IP Camera to access the Internet
through an xDSL service provider.
Select “Enable PPPoE connection” and enter your account and password details
as provided by your internet service provider (“ISP”).
Otherwise, leave it at the default “Disable PPPoE connection”
7. Click “Next >” to proceed with DDNS setup
iCAMView user manual -11-